Again this is how most fireplaces look after you remove the doors and or screens
and below is a clear base with blue over the top
The fireplace below has azurlite with ice as a topper.
This was a 2" installation with lava rock and sand as a base.
The fireplace below has clear. 1/4" Azurlite and 1/4" Azurlite Reflective.
Can you honestly say, "these logs look good"?
The fireplace below is in San Diego, California and the colors used were:
Cobalt Blue Topper G250CF
Steel Blue Topper G253CF
Cranberry Pink Topping #1311
Purple Topper G275CF
Lilac Topper G270CF
Deep Royal Topping #1114
1/4" Clear Base
1/4" Solex and 1/4" Solex Reflective
1/4" Azurlite and 1/4" Azurlite Reflective
1/4" Blue Green and 1/4" Blue Green Reflective
and a little bit of Ice Ice Ice on top
The end pictures show that the burner was too close the wall which was an easy fix by moving the burner forward.
This is where is went a little bit wrong. We just had them move the burner forward and now its fine and the back wall was repainted.
The 2 outdoor fireplaces below are in northern California at the Hyatt. They called us about soot on the glass.
When we looked at the pictures our first thoughts were PROPANE!
No these are natural gas.
The fix was actually very simple.
This was caused by a down draft from the chimney which we partially closed the flue which stopped the down draft and as you can see they are just fine now.
The fireplace below has a 3/8" Starfire Base with 1/4" Azurlite, Citrine Topper G265CF, Hyacinth Topper G272CF, Lagoon Topper G254CF, and 1/4" Platinum laminated to the back wall.
This was installed in Dallas Texas by Nadine.
The fireplace below has 1/4" Azurlite Base glass with Dark Red Orange Topper G235CF and Yellow Amber Topper G245CF on top.